Crown Moulding Jig Pt 1 YT



A simple jig to make for cutting crown moulding with a compound miter saw. To view part 2 follow this link: www.youtube.com For more please www.josephfusco.org

This entry was posted in Crown Molding Videos. Bookmark the permalink.

4 Responses to Crown Moulding Jig Pt 1 YT

  1. hopper1 says:

    Good to see another new video. By the way,? 22mm falls somewhere between 7/8″ and 13/16″. Now I’m off to watch part 2.

  2. joefusco1960 says:

    Thanks for the info, I’m sure you could see I said it off the top of my? head. I think when I measured the Festool clamp it measured 25/32″ 22mm sounded close ;-).

  3. DrewInTO says:

    Hi Joe, Just wondering: if you only use? 1 clamp on one side the jig. And replace other clamp with a stop block, would it help in repositioning the center point of the jig every time? Meanwhile, I guess we might save 1 clamp too.

    Just a thought.

    Andrew

  4. six5six1 says:

    joe you? the man for sure

Leave a Reply

Your email address will not be published. Required fields are marked *